Just say I have a 100 pixel RGB smart string and I have created an element with 100 nodes.
My question is when setting up the string in the Setup Preview screen I notice that you can only setup 2 points with the line tool, or three points to make a triangle or 4 points for a square.
For the example below there is three sides with 4 points. Say I want to set up 25 pixel on both the left and right side and 50 pixels going across the top. Can this be done without having to create three elements in Setup Display with 25, 25 and 50 pixels in each? If there's not already a way there should be a tool that has multiple points and you then just add in the number of pixels for each section, all done in Setup Preview screen.
----------------------
| |
| |
| |
For some reason I can't get that right pole to line up under the right end of the top pole. Picture it as a n.
If this can't be done it maybe a feature Vixen can add, what are your thoughts.
Thanks in advanced.
My question is when setting up the string in the Setup Preview screen I notice that you can only setup 2 points with the line tool, or three points to make a triangle or 4 points for a square.
For the example below there is three sides with 4 points. Say I want to set up 25 pixel on both the left and right side and 50 pixels going across the top. Can this be done without having to create three elements in Setup Display with 25, 25 and 50 pixels in each? If there's not already a way there should be a tool that has multiple points and you then just add in the number of pixels for each section, all done in Setup Preview screen.
----------------------
| |
| |
| |
For some reason I can't get that right pole to line up under the right end of the top pole. Picture it as a n.
If this can't be done it maybe a feature Vixen can add, what are your thoughts.
Thanks in advanced.