I'm not sure if this is an issue or expected behavior, but Ive run into a situation that confounds me...
When I edit a segment of lights (multiple channels segmented into one logical channel) and make my changes everything goes as expected. But if I save the routine, then come back to it later on (either by selecting another group of channels to work on and then coming back to the group with the segments in them or by closing HLS and reopening it) I get a solid bar in place of my effects.. .The only way I am able to edit it at this point is by going back to each individual channel and edit or remove the effect and start again... Is this intended behavior? or is there an issue?
THanks for all your hard work!
When I edit a segment of lights (multiple channels segmented into one logical channel) and make my changes everything goes as expected. But if I save the routine, then come back to it later on (either by selecting another group of channels to work on and then coming back to the group with the segments in them or by closing HLS and reopening it) I get a solid bar in place of my effects.. .The only way I am able to edit it at this point is by going back to each individual channel and edit or remove the effect and start again... Is this intended behavior? or is there an issue?
THanks for all your hard work!